It’s called regen braking and puts energy back into battery. You can also control how strong the regen is in settings.
I prefer strong regen and hold mode. The car will slow as soon as you release the accelerator pedal. Hold mode basically means the car stays put when it’s stopped until you press the accelerater. Creep mode would have the car roll forward when you release the brake.
The one pedal driving works really well but there is a small learning curve. I would find it a bit annoying to switch back and forth like the valet guy.
Regenerative braking happens through the brake pedal on my Ford PHEV. I prefer it, because it drives the same way every other car does but still allows you to stop with 100% regenerative braking as long as you don’t press too hard on the pedal.
Do you put your foot over the brake and maybe hold some pressure on the pedal?. Just asking as I’m going to just put this out there If not your doing it wrong. As a responsible driver your foot must at least press the brake pedal to hold you still and I’ll tell you why. What if you get hit from behind. Where is your foot? Over the brake or gas? Most people like 99 percent tense when hit with sudden stress. But are you going to clamp down and shoot into traffic or help everything behind you also come to a stop?
No they don’t. The hydraulic system is not used to stop you at any time unless your foot pushes that peddle. Do use your actual brakes everyonce in awhile so they don’t rust into place and fail to work when you need them.
I’ve had the car for 5 years, I’m familiar with how it works.
I did not say that the car uses the brakes to stop. I said that with hold mode, it applies the brakes once you are stopped. Also there is a mode to blend brakes with regen. This is used when the battery can’t accept any energy via regen. Usually when the charge level is close to 100% or the battery is cold. In order to provide consistent dynamics, the car will auto use brakes to make up for low regen.
Oh that the very bottom it says never rely on hold to ever anything that is literally their caveat to they are not liable to you. put your foot on the brake.
It’s called regen braking and puts energy back into battery. You can also control how strong the regen is in settings.
I prefer strong regen and hold mode. The car will slow as soon as you release the accelerator pedal. Hold mode basically means the car stays put when it’s stopped until you press the accelerater. Creep mode would have the car roll forward when you release the brake.
The one pedal driving works really well but there is a small learning curve. I would find it a bit annoying to switch back and forth like the valet guy.
Regenerative braking happens through the brake pedal on my Ford PHEV. I prefer it, because it drives the same way every other car does but still allows you to stop with 100% regenerative braking as long as you don’t press too hard on the pedal.
I like the instant response and feel its safer since the car will already be slowing down by the time I mash the brakes.
Do you put your foot over the brake and maybe hold some pressure on the pedal?. Just asking as I’m going to just put this out there If not your doing it wrong. As a responsible driver your foot must at least press the brake pedal to hold you still and I’ll tell you why. What if you get hit from behind. Where is your foot? Over the brake or gas? Most people like 99 percent tense when hit with sudden stress. But are you going to clamp down and shoot into traffic or help everything behind you also come to a stop?
I do not put my foot on the brake when its held. It does apply the brakes when the car stops so that should take care of the being rear ended issue.
No they don’t. The hydraulic system is not used to stop you at any time unless your foot pushes that peddle. Do use your actual brakes everyonce in awhile so they don’t rust into place and fail to work when you need them.
I’ve had the car for 5 years, I’m familiar with how it works.
I did not say that the car uses the brakes to stop. I said that with hold mode, it applies the brakes once you are stopped. Also there is a mode to blend brakes with regen. This is used when the battery can’t accept any energy via regen. Usually when the charge level is close to 100% or the battery is cold. In order to provide consistent dynamics, the car will auto use brakes to make up for low regen.
Here’s the manual for hold mode.
Oh that the very bottom it says never rely on hold to ever anything that is literally their caveat to they are not liable to you. put your foot on the brake.